Appliances Recalls

Hazard: The tiller's transmission shift rod and clip can come into contact with the control cable during shifting and cause the tiller to unintentionally move forward or backward, posing a risk of bodily injury and/or laceration.

Hazard: The thermal element in the TAFR can fail to operate, causing the users to come in contact with water that is hotter than expected. This poses a risk of scalding injury.

Hazard: The thermal probe in the base can conduct electricity throughout the cooker, posing a risk of electric shock.

Hazard: The socket can overheat, arc and melt, posing a fire hazard.

Hazard: Fuel can back up, creating unstable combustion and a pressure build up inside the firebox and glass can break, posing a laceration hazard.

Hazard: The bottom portion of glass vessel can break when heated and the contents can spill, posing laceration and burn hazards.

Hazard: The water heater's combustion chamber can be misaligned and heat the exterior walls of the water heater instead of the water. Combustible material near the outside of the water heater can catch fire, posing fire and burn hazards.

Hazard: The ranges' ovens can turn on by themselves, posing a burn hazard to consumers.

Hazard: The burner flame can go out while the gas is turned on. This can allow gas to escape and poses fire and burn hazards.

Hazard: The stainless steel trim below the range control panel can have a sharp edge, posing a laceration hazard to consumers.

Hazard: The filler cap at the top of the unit can crack and allow steam to escape, posing a risk of burns to the user. In addition, the cap can pop off unexpectedly as a result of pressure buildup, posing a risk of injury to a bystander.

Hazard: After the safety has been re-engaged, the crossbows can fire under certain circumstances if a consumer pulls the trigger, posing an injury hazard.

Hazard: The aluminum wand can disconnect from the vacuum cleaner's handle and remain energized with electricity, posing a risk of electric shock.

Hazard: The blower vacuum can overheat, spark and catch on fire posing fire and burn hazards.

Hazard: The blower vacuum can overheat, spark and catch on fire posing fire and burn hazards.

Hazard: On units with a space between the bottom of the water tank and the combustion chamber, the flame arrestor or flame arrestor plate can fail, posing a risk of fire or explosion if flammable liquids or gases are nearby.

Hazard: The tea cups are mislabeled as microwave safe. If microwaved, the gold paint accents on the teacups can spark, posing a fire hazard.

Hazard: The interior fan of the Turbo Tool accessory can break and eject from the tool housing, posing a laceration hazard to the user or bystanders.

Hazard: The heating element can fail to properly adhere to the cooktop, posing an electrical shock hazard to consumers.

Hazard: The ceiling fan hub holding the blades can separate from the shaft when operating in reverse. If this happens, the fan blades and hub can fall and pose a risk of injury to bystanders.

Hazard: The screws used to attach the back plate to the heater are too short and allow the back plate to detach when removing the heater from the outlet, posing an electrical shock hazard to the user.

Hazard: The sander can short circuit, posing a fire hazard.

Hazard: Water can overheat during brewing, spray out and burn consumers.

Hazard: The air purifier's circuit board can overheat and cause the air purifier to catch on fire.

Hazard: The battery packs can overcharge, overheat, bulge and melt the battery pack's enclosure, posing a fire hazard and risk of property damage.

Hazard: The steering control arm component can break under normal use, causing driver to lose control and crash.

Hazard: The water heaters can overheat, posing a fire hazard.

Hazard: Weld on drive axle can fail resulting in loss of brake control, posing an injury hazard.

Hazard: Vegetation and debris can accumulate on the middle skid plate and make contact with the vehicle's exhaust system. Dried debris can ignite, resulting in smoke or fire.

Hazard: The ground wire and probe wires could be incorrectly assembled in the units by the manufacturer, posing fire and explosion hazards.