Terex Equipment recall

Recalled January 25, 2008 · NHTSA recall 08E009000 · Terex

Hazard

DEBRIS MAY SCRATCH THE CYLINDER WALL OR GET INTO HOLDING VALVES AND CAUSE THE PLATFORM TO DRIFT DOWN SLOWLY, WHICH COULD POSSIBLY RESULT IN SERIOUS INJURY OR DEATH TO THE PLATFORM USER.

Remedy

TEREX WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE CHECK VALVES FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 7, 2008. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT BY CALLING 1-605-882-4000.

Units

1,167 units

Description

TEREX IS RECALLING 1,167 TC SERIES AERIAL DEVICES EQUIPPED WITH CHECK VALVE, P/N 443847, INSTALLED FROM SEPTEMBER 2001 UNTIL MARCH 2007. THE VALVE IS LOCATED ON THE LOWER BOOM LIFT CYLINDER. FAILURE CAN OCCUR ONLY WHEN THE VEHICLE IS PARKED AND THE AERIAL DEVICE IS IN OPERATION. THE CHECK VALVE IS USED IN RETIMING OF THE BOOM WHEN THE PLATFORM IS OUT OF LEVEL. THE FLOW THROUGH THE CHECK VALVE CAN CAUSE THE SNAP RING TO FAIL IF THE RETIMING FLOW IS ABNORMALLY HIGH. THE CHECK VALVE COMPONENTS WILL FLOW INTO THE LIFT CYLINDER IF THE SNAP RING FAILS.

What to do

TEREX WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE CHECK VALVES FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 7, 2008. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT BY CALLING 1-605-882-4000.

Product

Terex TC

Manufacturer(s)

Terex South Dakota, Inc.

Source: U.S. National Highway Traffic Safety Administration. Official recall notice on nhtsa.gov →