Home / Recalls / Vehicle Equipment
Moog 1998 Steering recall
Recalled October 6, 1998 · NHTSA recall 98E032000 · Moog
Hazard
WITHOUT THE COTTER PIN, IT IS POSSIBLE THAT THE NUT COULD LOOSEN IN SERVICE OR THAT THE STUD IN THE CENTER LINK COULD BE DAMAGED DURING THE TIGHTENING PROCESS. IF THE ARM DISCONNECTS AT THIS PIVOT POINT, THE CENTER LINK WILL BE ALLOWED TO DROP OUT OF ITS PROPER POSITION, CAUSING DISRUPTION TO THE STEERING.
Remedy
MOOG WILL REPLACE THESE IDLER ARMS WITH IDLER ARMS FROM ANOTHER SUPPLIER.
Units
95 units
Description
EQUIPMENT DESCRIPTION: AFTERMARKET IDLER ARMS FOR USE ON 1986 1/2 - 1995 NISSAN TRUCKS WITH 2-WHEEL DRIVE. A TAPERED HOLE IN THE LINKAGE END IS TOO SMALL IN DIAMETER SO THAT THE STUD IN THE CENTER LINK WILL NOT INSTALL TO THE CORRECT DEPTH. IT WOULD BE IMPOSSIBLE TO INSTALL THE COTTER PIN.
What to do
MOOG WILL REPLACE THESE IDLER ARMS WITH IDLER ARMS FROM ANOTHER SUPPLIER.
Product
Moog IDLER ARM
Manufacturer(s)
MOOG AUTOMOTIVE
Source: U.S. National Highway Traffic Safety Administration. Official recall notice on nhtsa.gov →